CMA Dishmachines CMA-180 Spécifications télécharger pdf (Page 6)

MODEL CMA-180 Service & Parts Manual Rev. 2.02A

2.2. Receiving and Installation

Step 1: Remove packaging material.

Step 2: Remove the Installation & Operation Manual from inside the wash tank.

Step 3: It is recommended that a distance of at least eight inches (8”) be

between the table scrap sink and the dishmachine.

2.2.1 Electrical*

The control panel provides a 1” conduit connection point on the rear of the panel.

Refer to Section 3 for wiring options.

This machine is equipped to handle both single and three phase applications.

See Section 1: Specifications 1.1 for the proper electrical ratings.

2.2.2 Plumbing*

Minimum 140°F / Minimum 180°F (if machine ordered without booster heater,

water supply ¾” – minimum 20 PSI, 6 GPM flow rate and 60 GPH recovery rate.

Plumbing connection located on the top of the machine.

The drain is a two-inch (2”) pipe sleeve attached by “No-Hub” plumbing

connection at the bottom of the scrap trap. The facilities drain must not be higher

than 11” to allow the machine to drain properly.

*Electrical and pluming connections must be made by qualified person who comply with all available

Federal, State, and Local Health, Electrical, Plumbing and Safety codes

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Pas de commentaire

CMA Dishmachines CMA-180 Spécifications Page 6